BIOTEQ

IDE-3296 RMC

Data Bus                32-bit PCI
Card Size               Half-length, half-height card
Hard Drives supported   Four IDE (AT) drives
Floppy drives supported None

[Image]

                                CONNECTIONS

       Function           Location           Function          Location

  40-pin primary             CN1       10-pin connector -        JP14
  IDE(AT) connector                    paddlecard
                                       (optional)

  40-pin secondary           CN2       2-pin connector -          LED
  IDE(AT) connector                    drive active LED

                        USER CONFIGURABLE SETTINGS

                  Function
                                                Label
                                                              Position

  »
      Disk change enabled
                                                JP13/1
                                                               Closed


      Disk change disabled
                                                JP13/1
                                                                Open

  »
      IDE base address enabled
                                                JP13/2
                                                                Open


      IDE base address disabled
                                                JP13/2
                                                               Closed

  »
      IDE(AT) interface enabled
                                                JP13/3
                                                                Open


      IDE(AT) interface disabled
                                                JP13/3
                                                               Closed

  »
      Native mode enabled
                                                 JP15
                                                               Closed


      Native mode disabled
                                                 JP15
                                                                Open

  »
      Secondary INT from drive
                                                 JP16
                                                             Pins 1 & 2
                                                               closed


      Secondary INT from chip
                                                 JP16
                                                             Pins 2 & 3
                                                               closed

  »
      Primary INT from drive
                                                 JP17
                                                             Pins 1 & 2
                                                               closed


      Primary INT from chip
                                                 JP17
                                                             Pins 2 & 3
                                                               closed

               PCI INTERRUPT SELECTION FOR PRIMARY IDE DRIVE

         Setting            JP12/1      JP12/2      JP12/3       JP12/4

   INTA (non-inverted)      Closed       Open        Open         Open

     INTA (inverted)         Open        Open        Open        Closed

     INTB (inverted)         Open        Open       Closed        Open

     INTC (inverted)         Open       Closed       Open         Open

            Note: In normal operation, JP12/4 is closed with primary
            drive INT14 using INTA. For OPTi54C and Pentium MBD, set
            JP12/1 closed, selecting non-inverted INTA.

              PCI INTERRUPT SELECTION FOR SECONDARY IDE DRIVE

         Setting
                            JP11/1
                                        JP11/2
                                                    JP11/3
                                                                 JP11/4

   INTB (non-inverted)
                            Closed
                                         Open
                                                     Open
                                                                  Open

     INTA (inverted)
                             Open
                                         Open
                                                     Open
                                                                 Closed

     INTB (inverted)
                             Open
                                         Open
                                                    Closed
                                                                  Open

     INTC (inverted)
                             Open
                                        Closed
                                                     Open
                                                                  Open

            Note: In normal operation, JP12/4 is closed with primary
            drive INT14 using INTA. For OPTi54C and Pentium MBD, set
            JP12/1 closed, selecting non-inverted INTA.

                       MISCELLANEOUS TECHNICAL NOTE

            If your system does not recognize PCI INT, remove jumpers
            JP11 and JP12 and install paddlecard.